| Benefits of this string jig over others: Precise measurements and repeatability Apply 300# of tension directly to the string being constructed. This is a great benefit to avoid "shooting in the string". Measure the string or cable length at 100# of tension. Direct measurement of string from back of pin to back of pin. This can be done by one person regardless of the string length. This is done by adding the measuring plate (provided) to a tape measure of your choice. Construct floating yokes and pig tail cable assemblies, complete with end loop servings, down to 10" in length. A tensioning and twisting crank is provided. This allows for the twisting of string and cable assemblies under tension from the center out without removal from the jig. Color separators are provided to separate two color assemblies for clean color separation. The jig requires a 1-5/8’ sq. Unistrut rail (NOT SUPPLIED). These rails are available locally at many larger hardware stores or electrical contractor supply houses. An instructional DVD will be shipped with each unit. The DVD is 180 minutes long and details the construction process of making strings and cable assemblies on this jig. This DVD may be purchased separately. |
| Ordering Information: Please contact by phone for latest prices and availability. Major credit cards, PayPal and MO’s are accepted. Phone: 800-437-9145 or 740-773-7423 Email: littlejon@horizonview.net |
| cable assembly to about 10 inches in length to allow loop serving with a standard serving tool. It may also be rotated around for fabrication of shorter strings. It has two width positions. The one shown is for shorter loop servings used on compound strings and the outer position is used for longer loop servings used on recurve strings. All parts are stainless steel. |
| The tensioner or tensioning unit is able to produce 300# of tensioning force from a compression spring. A built-in scale measures the compression of the spring. The drive screw is 1 / 2 - 1 0 ACME threaded. The housing is an aluminum casting and the steel pieces are stainless steel.. |
| Unistrut clamps on the tensioning unit are secured with a cross bar. This allows for easy repositioning of the tensioning unit. |
| to separate the two halves or colors. The crank will then twist the string between the separators. The string will be twisted from the center out. |
| A measuring plate is provided. The distance from the back of the hole to the front of the slot is 1 inch. The tape may be permanently or temporarily attached to the plate. The tape in |
| This is the swing arm assembly. It is shown with the removable helper post. In normal use, it can be rotated 90 degrees to open the string for applying the loop serving. It can open a bowstring or yoke |
| This procedure is for twisting a string. A spring plunger is pulled to release the drive screw for tensioning and twisting. Separator spools are used |
| this picture has been cut one inch back and the tape pop riveted to the plate. |
 |
 |
 |
 |